HPE Community
Web and Unmanaged
1753809 Members
8237 Online
108805 Solutions
New Discussion

1910-48G New VLAN Interface

 
SOLVED
Go to solution
rudders
Occasional Visitor

‎01-03-2019 05:40 AM

‎01-03-2019 05:40 AM

1910-48G New VLAN Interface

Hi all; - I created a new VLAN on this switch and added an IP address via a VLAN Interface. It is showing an admin state of "up", but the routing table has not been updated and I cannot ping this address.

The firmware is 5.20 Release 1519P03.

Should the routing table be showing a direct route via the loopbak to this new VLAN interface?

 

Thanks,
Sam

 

0 Kudos
1 REPLY 1
rudders
Occasional Visitor

‎01-03-2019 08:13 AM

‎01-03-2019 08:13 AM

Solution

Re: 1910-48G New VLAN Interface

Ah - read the manual and realised the issue was that no port was up in that VLAN. As soon as one was brought up the routes were added and all worked

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.