Web and Unmanaged
1748195 Members
4350 Online
108759 Solutions
New Discussion

Re: 1950 data voice vlan

 
SOLVED
Go to solution
raj567
Advisor

1950 data voice vlan

how to configure data and voice vlan in same port of 1950 HP switch

8 REPLIES 8
akg7
HPE Pro

Re: 1950 data voice vlan

Hi,

Try to setup port to trunk or hybrid and tagged the voice vlan and the data vlan should be untagged.
Also enable lldp or cdp as per the requirement.

 

Thanks!

Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the companyAccept or Kudo
akg7
HPE Pro
Solution

Re: 1950 data voice vlan

Hello @raj567 ,

Has my post helped you to answer your query?

Thanks!

Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the companyAccept or Kudo
raj567
Advisor

Re: 1950 data voice vlan

Hi

when I enter in to CLI Mode,I am getting <hp>.

unable to enter configuration mode.can you please tell how to enter config t or configuration mode.

 

RAJESH

raj567
Advisor

Re: 1950 data voice vlan

Hi

when I enter in to CLI Mode,I am getting <hp>.

unable to enter configuration mode.can you please tell how to enter config t or con

akg7
HPE Pro

Re: 1950 data voice vlan

 

vo1.JPG

 

 

2. Now go to Network->Interfaces and select interface which you want to configure for both. 

Follow the same as per the screenshots.

 

vo2.JPGvo3.JPG

 

3.  Network->Links->LLDP and follow the settings for the selected interface as below:

vo4.JPGvo8.JPGvo9.JPG

 

I hope this will help you.

Thanks!

 

Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the companyAccept or Kudo
raj567
Advisor

Re: 1950 data voice vlan

hi

 

thanks a lot.

hope vlan 2 is voice Lan and it should be tagged anf vlan 3 is data vlan and it should be untagged..

what is Qos setup to be done.

And also I am doing etherchannel from This L2 Switch( two Links from port 23 and 24) to 2 L3 Switch 2930f ( stacked L3 Switch ). access ports.

just if i make etehr-chgroup and give identication no is enough.

 

Rajesh

raj567
Advisor

Re: 1950 data voice vlan

hi

i did the way you guided me.still my IP phones not getting mac address.

I should add UID to switch.pls confirm

 

Thanks in advance

 

Rajesh

akg7
HPE Pro

Re: 1950 data voice vlan

Hi,

You can add UID.

Also share the screenshots.

Thanks!

Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the companyAccept or Kudo