- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Web and Unmanaged
- >
- Re: Can't Add members to Trunk
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-22-2014 06:57 AM - last edited on 11-02-2014 06:22 AM by Lisa198503
06-22-2014 06:57 AM - last edited on 11-02-2014 06:22 AM by Lisa198503
Can't Add members to Trunk
G'Day all.
I have an HP ProCurve 1810G - 24 GE running P.2.12. I am looking to enable LACP for some servers attached to the switch.
I can create a Trunk, but when I go to add members there is nothing availbe in the trunk ID drop down, and I have the message "No Trunks Available For Configuration".
Screenshots attached of both the Trunk Config and Trunk Membership pages. Config shows the trunk havign been created, but I can't add members.
Thanks in advance for any assistance.
P.S. This thread has been moved from ProCurve / ProVision-Based to Web and Unmanaged. -HP Forum Moderator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-29-2014 12:52 PM
10-29-2014 12:52 PM
Re: Can't Add members to Trunk
Hello,
I faced the same problem today using a HP 1810G-24: Under Trunks - Trunk Membership I just got the message "No Trunks Available For Configuration" and couldn't select the trunk I created before.
The solution was, in my case, quite simple: Instead of using Internet Explorer 11, I used Mozilla Firefox and now I could select the trunk I created before.
Hope this will help.
Kind regards