- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Web and Unmanaged
- >
- Cant Make Changes on Switch after Firmware Upgrade
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-07-2019 04:19 AM
11-07-2019 04:19 AM
Cant Make Changes on Switch after Firmware Upgrade
Hi everyone.
Ive just updated firmware on my V1910-24G Switch to version 1910-CMW520-R1519P06.
1. The Power LED is now not stable, its just blinking none stop.
2. When I access the Web Console, I can see all the Menus on the left. When I click on any of them, I get the Submenus. But when I try to open any of the Sub Menus, I get logged out and have to log back in. And this is happening with all the Sub Menus. So basically, I cant make any changes now on the Switch now.
I kept logging back in untill it said "Too many user curreently logged in" and wouldnt allow me in. Had to switch it Off and On again. The switch is otherwise working fine, in a sense that traffic is flowing thru it fine.
Please Help. Thank You.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-07-2019 05:40 AM
11-07-2019 05:40 AM
Re: Cant Make Changes on Switch after Firmware Upgrade
Hi Molatudi,
I understand that you have updated 1910 to the latest version and after that the switch was showing a strange behavior.
It the Power LED is still blinking then according to the manual the system is performing a POST.
See Appendix B LEDs:
https://support.hpe.com/hpsc/doc/public/display?docLocale=en_US&docId=emr_na-c03941554&withFrame
If you cannot access the submenus on the WEB GUI correctly and if you cannot do any configuration, can you please try to access the switch over console and try to downgrade to the old version.
If the switch is running fine on the old version then please download the new R1519P06 image from the below site and upgrade again.
https://h10145.www1.hpe.com/downloads/SoftwareReleases.aspx?ProductNumber=JE006A
If you are still experianing the same issue on R1519P06 please contact the HPE support when you open a case for further troubleshooting.
Best regards