HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Web and Unmanaged
cancel
Showing results for 
Search instead for 
Did you mean: 

Configuring Trunks between HP 1810G & HP2524

 
Prash29
Occasional Visitor

Configuring Trunks between HP 1810G & HP2524

Hi All

I'm trying to create a trunk between the HP1810G 24 port and a HP 2524 Switches.

The HP1810G Switch ahs ther main server connection. So if I connect any devies to the 1810G switch I can get a DHCP address and everything works. When I plug a device in the 2524 I can't get an DCHP address. I've check the logs and can see the port is being block. I've diabled Spanning tree completely.

Can any one help.

Thanks

Prash

 

P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to Web and Unmanaged. -HP Forum Moderator

2 REPLIES
Shadow13
Respected Contributor

Re: Configuring Trunks between HP 1810G & HP2524

how many cable are connected between the 2 switches, also how many vlans are you using ?

And by trunk you mesn link aggregation or trunk for vlans as in cisco ?
Prash29
Occasional Visitor

Re: Configuring Trunks between HP 1810G & HP2524

Hi Shadow13.

I'm using 1 cable which plugged in the Gigabit module on the 2524.

I'm not using any VLANS

Regards,

Prash