HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Web and Unmanaged
cancel
Showing results for 
Search instead for 
Did you mean: 

Configuring V1910-48g

 
wowmejames
Occasional Visitor

Configuring V1910-48g

Hi

I am a trying to find out if it is possible to configure an HP V1910-48g so that 802.3ad Link Aggregation is enabled on a couple of ports. I have a Mac Server with two NIC's (which are bonded together) and they were previously connected to a ProCurve 1800 in ports 1 & 2. all worked fine until I connected them up to a new switch and I get a message on the Mac saying that I need to enable 802.3ad Link Aggregation on these ports. Can anyone help?

I am running complete Mac network but might be able to get a MS laptop if needed to help configure.

 

Any pointers would be much appreciated.

 

 

P.S. This thread has been moved from Network Management > PCM to Web and Unmanaged. - Hp Forum Moderator