- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Web and Unmanaged
- >
- Re: HP 1810-24G will not reset
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-22-2013 10:23 AM - last edited on 05-28-2013 11:42 PM by Maiko-I
02-22-2013 10:23 AM - last edited on 05-28-2013 11:42 PM by Maiko-I
HP 1810-24G will not reset
I was attempting to setup link aggregation with a Synology RS812 NAS and the switch froze. I've attempted (multiple times) to reset the switch to factor defaults by:
- Holding down the "Reset" and "Clear" on the front panel
- Releasing "Reset"
- Releasing "Clear" after the LED Mode lights flash twice
The switch will not come up completely. Fault indicator is flashing and ports 9-16 have the link light blinking. This configuration implies fault other than self-test. This says configuration fault to me, but I thought I was following the instructions to reset to factory defaults above.
Ideas?
P.S. This thread has been moved from ProCurve / ProVision-Based to Web and Unmanaged - HP Forum Moderator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-22-2013 11:41 AM
02-22-2013 11:41 AM
Re: HP 1810-24G will not reset
Well I submitted a ticket to HP, within 30 minutes I had a phone call and a new switch on it's way for overnight delivery. No arguments.
All I can say is that this kind of service will keep me coming back to HPs Procurve networking gear.
Rare that you get that kind of service these days, at least in my experience.