HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Web and Unmanaged
cancel
Showing results for 
Search instead for 
Did you mean: 

HP 1910-28G and Linux 802.3ad

 
gfirf
Occasional Visitor

HP 1910-28G and Linux 802.3ad

Hello, I have a trouble with configure Dynamic LAG between

HP 1910-28G and linux 3.11.0-15-generic #25~precise1-Ubuntu SMP Thu Jan 30 17:39:31 UTC 2014 x86_64 x86_64 x86_64 GNU/Linux

 

When i create new Dynamic LAG the linux host become unreachable.

On Web UI: LAG state: Reason for being Unselected. The port is not configured properly.

LACP screenshot https://www.dropbox.com/s/qs4yf5ml4fvkp0l/lacp.png

 

 

 cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)

Bonding Mode: IEEE 802.3ad Dynamic link aggregation
Transmit Hash Policy: layer2 (0)
MII Status: up
MII Polling Interval (ms): 50
Up Delay (ms): 0
Down Delay (ms): 0

802.3ad info
LACP rate: slow
Min links: 0
Aggregator selection policy (ad_select): stable
Active Aggregator Info:
        Aggregator ID: 1
        Number of ports: 1
        Actor Key: 17
        Partner Key: 1
        Partner Mac Address: 00:00:00:00:00:00

Slave Interface: eth0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:17:08:5a:d7:0f
Aggregator ID: 1
Slave queue ID: 0

Slave Interface: eth1
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:17:08:5a:d7:0e
Aggregator ID: 2
Slave queue ID: 0

 

It's possible to connect Linux and HP 1910 with 802.3ad?

 

 

P.S. This thread has been moved from ProCurve / ProVision-Based to Web and Unmanaged. -HP Forum Moderator