HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Community
Web and Unmanaged
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

HP 1920 QoS Command Line Best Practice

 
ukonstantin
ukonstantin
Occasional Advisor

‎12-17-2015 09:28 PM

‎12-17-2015 09:28 PM

HP 1920 QoS Command Line Best Practice

Hello,

i would like to configure in a 1920 Switch QoS for Voice. 

On some ports there are IP Phons with PCs conncected. We need to mark voice with DSCP ef and all other traffic with 0. i didn't find the command reference for that.

thanks

udo

 

 

0 Kudos
Reply
1 REPLY
16again
16again
Respected Contributor

‎12-17-2015 11:26 PM

‎12-17-2015 11:26 PM

Re: HP 1920 QoS Command Line Best Practice

This switch can only apply a single action on a port.
So it's either marking data packets as dscp 0
or
marking VOIP packets as EF

Just configure the phones to do the markings, and trust DSCP value on ports connected to phones

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.