HP 1920 Switch Series - NOT Usable for IPv6 SLAAC

[xdom]

The HP 1920 is Similar to the Cisco SG300 Switch Series. Unfortunately the HP 1920 dont have a usable IPv6 Implementation because it doesn't send Router Advertisements from any VLan Interface. Without this Feature it couldn't be used for Client Switching because its not possible to configure the IPv6 Addresses automatically(SLAAC).

If i configure a Router Device in the Same VLan all the Routable Traffic from the Clients will be Routed over the Router and not over the Layer 3 Routing Function of the Switch.

Will this be implemented by a newer Version?

Regards
José Roig

[16again]

Seems like RA is default disabled, use commands below to enable RA per VLAN.

Disclaimer:  Tested on home switch, non production. Use at your own risk.

telnet 192.168.1.1

******************************************************************************
* Copyright (c) 2010-2015 Hewlett-Packard Development Company, L.P.          *
* Without the owner's prior written consent,                                 *
* no decompiling or reverse-engineering shall be allowed.                    *
******************************************************************************

Login authentication

Username:admin
Password:
<HP1920G>_cmdline-mode on
All commands can be displayed and executed. Continue? [Y/N]y
Please input password:Jinhua1920unauthorized
Warning: Now you enter an all-command mode for developer's testing, some command
s may affect operation by wrong use, please carefully use it with our engineer's
 direction.
<HP1920G>system-view
System View: return to User View with Ctrl+Z.

[HP1920G]display version
HP Comware Platform Software
Comware Software, Version 5.20.99, Release 1107
[HP1920G]interface Vlan-interface 1
[HP1920G-Vlan-interface1]undo ipv6 nd ra halt