HP Procurve 1810G and Engenius ECB 9500 AP

[iChristiaan]

The Engenius accesspoint has Multiple SSID with 802.1q VLAN Tagging and I want to setup two SSID's, one ssid who can only connect to the internet and one ssid who can connect to my network and the internet. I use a Draytek Vigor 2130 router who supports port-based VLAN. Port 4 on the Vigor 2130 is isolated from port 1, 2 and 3. So port 4 can only access the internet because my internal network is on port 1, 2 and 3. Port 1,2 and 3 can also access the internet.

I want to use the 1810G-8 for the multiple SSID with one guest SSID for only internet access and one SSID for internet en network access on the Engenius accesspoint.

I want to connect the engenius on port 8, port 4(only internet access) of the vigor on port 6 and port 3 (internet en network access) of the vigor on port 7.

Port 6   Internet           

Port 7   Network   / Internet       

Port 8   AP       

Vlan 2   (Vlan ID=2, PVID=2)

Port 6   U

Port 8   T

Vlan 3   (Vlan ID=3, PVID=3)

Port 7   U

Port 8   T

Will the above configuration do this job or do i need to use a port thrunk?

P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to Web and Unmanaged. -HP Forum Moderator