Web and Unmanaged
cancel
Showing results for 
Search instead for 
Did you mean: 

HP v1910-24G-PoE and Voice Vlans

ludwigmey
Occasional Visitor

HP v1910-24G-PoE and Voice Vlans

I have 5 HP v1910-24G-PoE switches in the following configuration :

 

vlan 1 – 192.168.0.0/24 (untagged 1-21,23-24) (default vlan)

Vlan 2 – 192.168.5.0/24 (untagged port 26)

Vlan 3 – 192.168.4.0/24 (untagged port 27)

Vlan 4 – 192.168.3.0/24 (untagged port 28)

Vlan 5 – 192.168.2.0/24 (untagged port 22)

 

I have a VoIP PABX (10.5.13.146/28) which is connected to a mikrotek router (10.5.13.145/28) and it also has an ip of 192.168.0.238 (they are on port 18 and 19, I have no access to this device).

 

The configs at each of the segments are configured as follows:

192.168.5.1/24 – default vlan gw 192.168.5.254 (on the 192.168.0.1)

192.168.4.1/24 – default vlan gw 192.168.4.254 (on the 192.168.0.1)

192.168.3.1/24 – default vlan gw 192.168.3.254 (on the 192.168.0.1)

192.168.2.1/24 – default vlan gw 192.168.2.254 (on the 192.168.0.1)

 

The PABX is an Alcatel-Lucent OmniPCX and all phones are Lucent 4018 IP Phones.

 

The phones have a config similar to this:

ip paramater

ip mode: dynamic

ip address: 10.5.13.150

subnet: 255.255.255.240

router: 10.5.13.145

tftp1: 10.5.13.146

tftp2: 255.255.255.0

tftp port: 69

cpu1: 10.5.13.146

cpu2: 255.255.255.0

use VLAN: no

Vlan ID: 4095

strict VLAN: yes

DHCP UserClass: no

class: iptouch.class0

 

Ive also been told that the MAC range is 00:80:9F:00:00:00 – 00:80:9F:FF:FF:FF

 

I need to deploy IP phones on each one of the segments without destroying the current vlans (the phones work fine on the 192.168.0.0/24 range). 

From what I have read I should be able to setup manual voice vlans on the switches, but I am not sure how to go about this process.  The documentation on the switches are not very clear to me.  Can anyone point me in the right direction please?

 

Thank you