HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Web and Unmanaged
cancel
Showing results for 
Search instead for 
Did you mean: 

LACP on 1810G 24 Port Switch

 
Eric F Crist
Occasional Visitor

LACP on 1810G 24 Port Switch

I have a problem getting more than 926Mb/s on a four port LACP to a FreeBSD box over gigabit ethernet with cat-6 wiring.

Both the FreeBSD ifconfig output and web interface for the switch indicate all four ports are active, however.

Any ideas on what I may be missing?

 

 

P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to Web and Unmanaged. -HP Forum Moderator

1 REPLY
Richard Brodie_1
Honored Contributor

Re: LACP on 1810G 24 Port Switch

You have to be careful about load balancing with LACP. I think the Procurves hash source/address destination address pairs.

If you were load testing from (say) a single 10Gb port on other system, that would explain it.