Port Policy Configuration Failure - HPE 1920

[MBL16]

Hi, 

i'm trying to configure a port policy on several ports. I've build a classifier and a behavior, which i've then assigned to a qos policy. My problem ist, that if i try to set this policy to any port, i've got a failure message.  It says only "Failure!".

What is wrong here?

Thanks in advance!

Kind regards

[16again]

post your config

[mickd08]

Have you applied an acl to the traffic classifier ?

I was having this same problem when trying to classify by vlan, i had to add an acl aswell !