QoS on V1910-24G PoE

[cepacs]

I have a V1910-24G PoE switch and that we will be using for phones and data and I need to configure QoS.  All I would like to do is give the Voice VLAN priority over the Data VLAN.  How would I do this?  The QoS seems so confusing in the manual.  I have the Voice VLAN port state enable on the ports with phones connected, but I'm thinking this doesn't provide any QoS, right?

Any help with QoS would be greatly appreciated!

Thanks,

Sebastian

[TJtheone · Accepted solution]

I'm not expert but you can try by enabling auto QoS or you can do in the port  trust the DSCP or IP proceeding value if your phone mark it or othervise set DSCP value to 5 in the port

[cepacs]

Thanks for the reply!  What does the DSCP value of 5 do?  The person setting up the Mitel 3300 asked me what priority I was giving voice on the switch.  He said he had the Mitel 3300 set to 6... is he talking about the DSCP?

[cepacs]

Ok, now I see... priority 6 goes along with 802.1p.  Thanks for the help!