Routing Between Vlans - V1910-24G JE006A

[DanielCavini]

Hi, i'm fresh in vlans configuration and i need some help to configure static routes in my switch. I have the folowing scenario:

vlan1 - 192.168.130.x

vlan25 - 192.168.120.x

vlan26 - 192.168.70.x

my Domain controler is on the vlan26  x.x.70.5 and i need to configure static routes for al computers on vlan25 and on vlan1 reach my Domain Controler ip.

Please Help.

Thanks 

P.S. This thread has been moevd from LAN Routing to Web and Unmanaged. - Hp Forum Moderator

[Fredrik Lönnman]

What device is the default GW for the computers? If its the switch, then nothing extra needs to be done.

[DanielCavini]

Its a Linux router/Gateway/DHCP with 4 nics, 1 external and 3 lan's 1 for each vlan for dhcp.

but when i trace from an ip 192.168.130.138 to my server 192.168.70.5 the trace stops at my gateway 192.168.130.1

in the system the dhcp server create a gateway for each nic: eth0: gateway 192.168.130.1 range 130.2 to 130.254; eth1: gateway 192.168.120.1 range 120.2 to 120.254; eth2: gateway 192.168.70.100 range 70.101 to 70.254.

the system generates routing between each nic vlan, but only for the address in the assigned by the dhcp. and my server ip is static. 

So i think i could input static routes to my server to vlans 120.x and 130.x  on the switch.

[meirhasin]

when you configure VLAN on HP and you enter the command "ip routing" the vlans automaticly connecet each other.
so you need to check the configuration in your linux.
please try to explain the linux configuration in better way.

[Phophus]

Hi

Am facing similar issue but the switch is my gateway.

I can ping from my Management Vlan but not vice versa.

Please advise.

[OffColour]

Same for me. I can ping from VLAN 1 to VLAN 30, but not vice-versa.

[OffColour]

Every single time I post to a forum I find the answer almost immediately afterwards... The box I was pinging in VLAN 1 still had the router as gateway rather than the switch.