Web and Unmanaged
cancel
Showing results for 
Search instead for 
Did you mean: 

Set parameter MEDIA TYPE Switch 1920-48G

 
quinhosp
Occasional Contributor

Set parameter MEDIA TYPE Switch 1920-48G

Good Morning!
I am in need of a help on on the switch 1920-48G JG927A. The first block of ports does not work some of the physical ports; I could verify in comparison with other physical ports of the same switch that the MEDIA TYPE is configured as fiber optic, but in fact it should be as twisted pair.
I already accessed the configuration by cmdline-mode on to try to make the change to twisted pair, but I could not find a way to do this.
The configuration parameter to be addressed is MEDIA TYPE, which I can not change in the 1920-48G optical fiber model for twisted pair.
3 REPLIES 3
parnassus
Honored Contributor

Re: Set parameter MEDIA TYPE Switch 1920-48G

Pretty strange...if it recognizes a block of copper ports as SFP slots...is really worrying (the JG927A owns 4 SFP ports, latest four on the frontplane right side).

Which software release is your JG927A currently running on? does it run on R1120 or older?

Can you provide (sanitized) running configuration?

quinhosp
Occasional Contributor

Re: Set parameter MEDIA TYPE Switch 1920-48G

Good Morning! Sorry for the delay. The version I use is R1120.

Current boot app is: flash:/jg927a-cmw520-r1120.bin

Below are the settings for port 1 and port 17 for a comparison.
Alerting that the to 07 works normally and port 1 does not work.
I recall that I believe that port 1 is configured for fiber optics and would like to change this configuration.

[HPE-GigabitEthernet1/0/1]display interface GigabitEthernet 1/0/1

GigabitEthernet1/0/1 current state: DOWN

IP Packet Frame Type: PKTFMT_ETHNT_2,

Description: GigabitEthernet1/0/1 Interface

Loopback is not set

Media type is optical fiber, Port hardware type is No connector

Unknown-speed mode, unknown-duplex mode

Link speed type is autonegotiation, link duplex type is autonegotiation

Flow-control is not enabled

The Maximum Frame Length is 9600

Broadcast MAX-ratio: 100%

Unicast MAX-ratio: 100%

Multicast MAX-ratio: 100%

PVID: 1

Mdi type: auto

Port link-type: access

Tagged VLAN ID : none

Untagged VLAN ID : 1

Port priority: 0

--------------------------------------------------------------------------------------------------------------------

[HPE-GigabitEthernet1/0/1]display interface GigabitEthernet 1/0/17

GigabitEthernet1/0/17 current state: DOWN

IP Packet Frame Type: PKTFMT_ETHNT_2,

Description: GigabitEthernet1/0/17 Interface

Loopback is not set

Media type is twisted pair, Port hardware type is 1000_BASE_T

Unknown-speed mode, unknown-duplex mode

Link speed type is autonegotiation, link duplex type is autonegotiation

Flow-control is not enabled

The Maximum Frame Length is 9600

Broadcast MAX-ratio: 100%

Unicast MAX-ratio: 100%

Multicast MAX-ratio: 100%

PVID: 1

Mdi type: auto

Port link-type: access

Tagged VLAN ID : none

Untagged VLAN ID : 1

Port priority: 0

quinhosp
Occasional Contributor

Re: Set parameter MEDIA TYPE Switch 1920-48G

Look at the MEDIA TYPE parameter, where I say it's different. On port 1 it is configured as fiber optic, but it is twisted pair port on the physical.