HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

V1900 PCM+

 
Weber_1337
Occasional Contributor

V1900 PCM+

Helo!

I want to integrate some V1900-8g into the PCM+ 3.2 both have the latest software installed. Due to the fact that this Switch does not support CDP/LLDP, I tried to initialize the manual discovery but when the Write Community Test starts an error appears. Like I have entered the wrong data but its correct.

Someone an idea?
4 REPLIES
Birthwell
Occasional Advisor

Re: V1900 PCM+

This switch does not support SNMP protocol.
It is a (HTTP based) web managed switch.
Hope this helps.
Birthwell
Occasional Advisor

Re: V1900 PCM+

This switch does not support SNMP protocol.
It is a (HTTP based) web managed switch.
Hope this helps.
Birthwell
Occasional Advisor

Re: V1900 PCM+

This switch does not support SNMP protocol. PCM+ is an SNMP protocol based application.
The switch is just a (HTTP based) web managed switch.
Hope this helps.
Weber_1337
Occasional Contributor

Re: V1900 PCM+

Thanks for your reply.

I am just wondering, if thw Switch does not Support SNMP, why were I able to configure the Read and Write Community properly in the Switch?

The above described Error apears while the PCM Cheks the Read and Write Community connectivity. The Read Community works fine but the Write Community produces the error.