HPE Community
Web and Unmanaged
1753331 Members
5216 Online
108792 Solutions
New Discussion

Re: V1910 24 Port Switch: Bind ACL to Port

 
MrJohnDoe
Occasional Contributor

‎10-31-2012 08:40 AM - last edited on ‎07-21-2013 10:30 PM by

‎10-31-2012 08:40 AM - last edited on ‎07-21-2013 10:30 PM by

V1910 24 Port Switch: Bind ACL to Port

Hi guys,

 

How do I bind a Advanced or Basic ACL to a port?

I didn't found any information in the manual.

 

I have attached a screenshot.

There is an advanced ACL. But what is it doing at the moment?

It isn't binded to a port.

 

 

Best Regards

Vincent

 

 

 

P.S. This thread has been moved from Switching > Switches, Hubs, Modems (Legacy ITRC forum) > to Web and Unmanaged.-HP Forum Moderator

0 Kudos
1 REPLY 1
AndriySurzhenko
Occasional Contributor

‎11-14-2012 11:52 AM

‎11-14-2012 11:52 AM

Re: V1910 24 Port Switch: Bind ACL to Port

try to use CLI mode

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.