HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Web and Unmanaged
cancel
Showing results for 
Search instead for 
Did you mean: 

can't configure trunk

 
SOLVED
Go to solution
jriker1
Occasional Advisor

can't configure trunk

I have some HP ProCurve 1810-24G switches and can't seem to configure a trunk between them.  Right now do the following:

  1. Login
  2. Click on Trunks and then Trunk Configuration
  3. Create a new trunk which is for testing called Interface Trunk1 Name test.  Static is unchecked.
  4. Click on Trunk Membership
  5. Click on Trunk ID pulldown and only option is None.  Trunk ID "Trunk1" doesn't show in the list.  Thoughts?

Thanks.

 

JR

3 REPLIES
jriker1
Occasional Advisor
Solution

Re: can't configure trunk

Figured it out, had to put IE into compatibility mode.  That said, how do I set the trunk mode?  In the manual it shows the option to set a trunk mode to LACP active or passive but I do not have that option or even that column.  Just radio buttons to set to static or not.

 

Thanks.

 

JR

parnassus
Honored Contributor

Re: can't configure trunk

Is it a J9803A (latest Firmware released is PL.2.07 <- Release Notes seems not available as standalone PDF document, you can find it into the related Firmware download archive) so a HP 1810-24G v2 or just a J9450A (latest Firmware released is P.2.18) so a HP 1810-24G?

What's the Firmware that is it actually running?

jriker1
Occasional Advisor

Re: can't configure trunk

I am on 2.16, didn't even know a 2.18 existed as I just updated these the other month.