HPE Community
Web and Unmanaged
1752339 Members
5636 Online
108787 Solutions
New Discussion

v1810g switches and port activation too slow

 
Anon4343
Occasional Advisor

‎01-09-2015 09:46 AM - last edited on ‎01-11-2015 10:36 PM by

‎01-09-2015 09:46 AM - last edited on ‎01-11-2015 10:36 PM by

v1810g switches and port activation too slow

We're experiencing a problem with newer SSD based Windows computers where the startup times are too fast for the network. The network connection does not appear to be initiating fast enough for the computers to receive software deployed through group policy. The deployment fails with an error message staying that the network location cannot be found. If we plug in a cheap home use switch inbetween the HP switch and the computer, the deployment will succeed.

 

 

With Cisco switches, you generally enable FastPort on the ports used for connected endpoint devices. On the HP switches, you would use the 'spanning-tree a1 admin-edge-port' command. However, this command does not appear to be available on the v1810g switches.

 

 

What do you suggest as a solution?

 

 

P.S. This thread has been moved from ProCurve / ProVision-Based to Web and Unmanaged. - Hp Forum Moderator

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.