- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Web and Unmanaged
- >
- v1910 stack vlan
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-22-2014 09:31 PM - last edited on 07-27-2014 07:34 PM by Lisa198503
07-22-2014 09:31 PM - last edited on 07-27-2014 07:34 PM by Lisa198503
v1910 stack vlan
Hello. I have 2 switches v1910 series. I tried stacking it together and I found out stack's switch can manage on VLAN 1 only.
[stack_0.HP V1910 Switch]display stack
Role : Master
Management VLAN : 1
IP Pool : 192.168.1.1/24
Total device number: 2
I’d rather manage stack's switches in VLAN 10. I have removed Vlan 1 interface before built stack, but after stack was built, Vlan1 active again. How can I change Management VLAN of stack?
Thanks.
P.S. This thread has been moved from ProCurve / ProVision-Based to Web and Unmanaged. -HP Forum Moderator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-22-2014 10:02 PM
07-22-2014 10:02 PM
Re: v1910 stack vlan
Use the CLI to issue a management-vlan 10 command
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-22-2014 10:19 PM
07-22-2014 10:19 PM
Re: v1910 stack vlan
Switch don't have this command or I don't know where I should write down it.
[stack_0.HP V1910 Switch]?
System view commands:
...
loopback-detection Detect if loopback exists
mac-address Configure MAC address
mac-authentication Specify Mac-auth configuration information
mac-vlan Specify the MAC VLAN configuration information
mirroring-group Specify mirroring-group
mld-snooping Enter mld-snooping view
monitor-link Configure monitor link
multicast-vlan Multicast VLAN
ndp Neighbor discovery protocol
...