HPE Community
Appliance Servers
1751773 Members
4449 Online
108781 Solutions
New Discussion юеВ

Default gateway on hp sa1100

 
Rolf Luettecke
Occasional Contributor

тАО12-28-2001 05:51 AM

тАО12-28-2001 05:51 AM

Default gateway on hp sa1100

Hi,
I've tried to setup an hp-webserver sa1100 to use a host-route as his default gateway. On every restart i manually have to adjust this setting, because the machine doesn't accept this route. Logging in via ssh and setting these parameters by hand and saving these settings from within the web-interface works until the next reboot. Any clou?
(i.e. IP=220.212.34.45 Default-GW=172.31.2.1)

Regards
Rolf
In dubio pro fessional
0 Kudos
2 REPLIES 2
CA592260
Frequent Advisor

тАО01-02-2002 11:17 AM

тАО01-02-2002 11:17 AM

Re: Default gateway on hp sa1100

Are you making changes to /etc/rc.config.d/netconf ?? or by using the route add command??

live free or die
harry
Live Free or Die
0 Kudos
CA188158
Honored Contributor

тАО01-03-2002 05:51 AM

тАО01-03-2002 05:51 AM

Re: Default gateway on hp sa1100

If SAM is available, it is easy to use this tool to set most parameters.

Not sure if the sa1100 was Linux or HPUX.
It is always a good day when you are launching rockets! http://tripolioklahoma.org, Mostly Missiles http://mostlymissiles.com
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.