Network

[technical task]

I am sorry for my English.
I have 2 switchboards: "Procurve 2810g-48" and "Procurve 2510g-48". They sostakovany between itself. Also there is a server of "HP Proliant Dl380g5" with the set virtual machine. It is needed two network this server to unite in timu, thus one network will be connected in one svich, and second in the second. Is it possible to realize on a present equipment, if and that as?

P.S. This thread has been moevd from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp Forum Moderator

[Mohammed Faiz]

Hi,

I'll try translating :)
So you have a Proliant server running a Virtual Machine and you want to present two networks to this virtual machine from the two ProCurve switches?
For example, VLAN 1 on the 2810 and VLAN 2 on the 2510 and the Virtual machine has an IP address on both VLANs. Is that right?

[technical task]

2 switchs is united in stak: 2810-48g (Commander) and 2510g-48 (Candidate).
My server (Proliant) have two network card and installed HYPER-V machine.
I want to create team.
I set IP (10.12.0.4) for team.
And I set IP (10.12.0.5) For HYPER-V.
Then I want connect the first network card in 2810, and second card in 2510.
Does it wake to work? And if will it be, as it to do?

Thank's

[Tijl van der Steeg]

This will work, as long you use fault tolerance and not load-balancing. I'm not sure which one Hyper-v supports