HPE Community
Automated Backup
1826428 Members
3744 Online
109692 Solutions
New Discussion

"no drive" displayed on DLT 718 autoloader

 
tim tye
New Member

‎06-11-2002 12:32 PM

‎06-11-2002 12:32 PM

"no drive" displayed on DLT 718 autoloader

I have a HP 718 DLT autoloader that is displaying the message, "no drive". The backup software will not work as it says there is no drive as well. I cannot find any resolution to this.

Please advise. Thank you very much.
0 Kudos
2 REPLIES 2
Stephane Bernou
Occasional Contributor

‎06-12-2002 01:38 AM

‎06-12-2002 01:38 AM

Re: "no drive" displayed on DLT 718 autoloader

Hello,
Did you connect all Scsi cable to the back of the autoloader, and the terminator?
best regards,
0 Kudos
CA628575
Trusted Contributor

‎06-12-2002 04:54 AM

‎06-12-2002 04:54 AM

Re: "no drive" displayed on DLT 718 autoloader

This is most likely a hardware problem. Take a look at the following thread: http://forums.itrc.hp.com/cm/QuestionAnswer/0,,0x016d42308663d611abdb0090277a778c,00.html
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.