BladeSystem - General
1748287 Members
3369 Online
108761 Solutions
New Discussion юеВ

1/10GB VC_ENET module replacement

 
Twister
Occasional Advisor

1/10GB VC_ENET module replacement

I tried to swap out a defective module but the replacement would not get a configuration from VC Mngr.

Is there any steps I should take to replace this module. I was replacing the standby module in slot 2?

Thanks
2 REPLIES 2
WFHC-WI
Honored Contributor

Re: 1/10GB VC_ENET module replacement

I found this once but after failing over the OA to the standby and then failing back over the problem resolved itself.
JKytsi
Honored Contributor

Re: 1/10GB VC_ENET module replacement

Check the firmware level on replacement module. Both modules should have same version and it should be supported by the OA firmware.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi