BL465c: High Temperature Condition detected by Processor

[RTCL Admin]

One of the BL465c G1 in a c7000 BladeSystem gives this message after POST:

High Temperature Condition detected by Processor

I found the following article on the web. The OA is 2.10 but the BIOS is an old one (12/02/2006). I tried to upgrade OA to 2.13 and downgrade to 1.30, but neither help. I also upgrade iLO2 to 1.50 but that didn't help, either. The blade was also removed and reinserted a couple of times. Since I couldn't get into any OS, I couldn't update the BIOS of the blade. How can I get pass the POST? Any suggestion?

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c00880424〈=en&cc=us&taskId=115&prodSeriesId=1844065&prodTypeId=329290

Howard

[RTCL Admin]

I tried to reinsert the blade, reset its configuration using the 6th position on SW1, reboot OA (2.13), but none of these approaches helps. I still see the "High Temperature Condition detected by Processor" error message after POST.

Is there anything else I can do?