HPE Community
BladeSystem - General
1752565 Members
5652 Online
108788 Solutions
New Discussion

Re: BL860C QMH2462 SAN Boot

 
Shift Support
Occasional Advisor

‎10-01-2008 02:48 PM

‎10-01-2008 02:48 PM

BL860C QMH2462 SAN Boot

Does anyone know where documenation is or how to configure the server (BL860c) to add a boot device from the SAN (using QMH2462 Qlogic FC adapter). I have seen the whitepaper but it does not say how to configure EFI
Thanks
0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎10-01-2008 09:49 PM

‎10-01-2008 09:49 PM

Re: BL860C QMH2462 SAN Boot

Do you have hp-ux running?

If yes, you can use "setboot" to create EFI boot entries.

If you are on EFI, you need to do a "deep" scan of the SAN, see

http://docs.hp.com/en/AB587-96012/ch05s06.html

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.