- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Blade shows as "Absent"
BladeSystem - General
1753675
Members
5001
Online
108799
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-05-2009 06:13 AM
10-05-2009 06:13 AM
Blade shows as "Absent"
Hi There,
I was wondering if there are any further steps I can take to make a blade show up in a bay that is seemingly not working.
I have a BLc3000 with a BL460c in Bay 5 of the enclosure but the KVM shows it as absent. If I put the Expansion blade in bay 5 it will show up as an "Unsupported Blade" but once I put the 460 in Bay 5 it shows as Absent. The blade sever in any other bay works fine. Any ideas?
I have updated all firmware (Blade and OA)and tried power cycling a few times.
Thanks,
Walter
I was wondering if there are any further steps I can take to make a blade show up in a bay that is seemingly not working.
I have a BLc3000 with a BL460c in Bay 5 of the enclosure but the KVM shows it as absent. If I put the Expansion blade in bay 5 it will show up as an "Unsupported Blade" but once I put the 460 in Bay 5 it shows as Absent. The blade sever in any other bay works fine. Any ideas?
I have updated all firmware (Blade and OA)and tried power cycling a few times.
Thanks,
Walter
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP