HPE Community
BladeSystem - General
1753634 Members
5771 Online
108798 Solutions
New Discussion юеВ

Re: Blinking Amber LED

 
swingarm
Occasional Advisor

тАО04-24-2008 01:26 PM

тАО04-24-2008 01:26 PM

Blinking Amber LED

I have some BL460c G1's and about 3-6 of them have a blinking amber health LED. Onboard Admin says the health is ok and there's nothing unusual in the logs. They are running the OS(Linux) normally. Onboard Admin firmware is at 2.13 and the ILO2 firmware is at 1.50. I have looked high and low to see what this means but I can't find any answers.
0 Kudos
Reply
2 REPLIES 2
JKytsi
Honored Contributor

тАО04-24-2008 09:34 PM

тАО04-24-2008 09:34 PM

Re: Blinking Amber LED

Check the IML log (and clear it). Have You checked the hard drives?
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Reply
swingarm
Occasional Advisor

тАО04-28-2008 02:35 PM

тАО04-28-2008 02:35 PM

Re: Blinking Amber LED

I have checked the IML log and there was nothing unusual in it then I cleared it. The hard drive is fine, it's running the OS normally atm on all the blades with the blinking amber LED. Nobody knows what a blinking amber LED means?
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.