BladeSystem - General
Showing results for 
Search instead for 
Did you mean: 

Re: C3000 upgraded gone bad


C3000 upgraded gone bad

I have recently upgraded our c3000 from 3.55 to 3.71 and now it keeps rebooting. It gets to step 7/16 on the insight display and then reboots.  any ideas?

Honored Contributor

Re: C3000 upgraded gone bad

its been a week, so perhaps you have a solution, but I would have tried powering down the enclosure and physically reseating the OA module.  


If that did not help, you could try connecting to the serial port of the OA to a terminal and see if you are getting any specific error messages.  In the end it could be that the OA needs replacing.



Was this helpful? Like this post by giving me a thumbs up below!
Super Advisor

Re: C3000 upgraded gone bad

how many OAs on C3000? try to use the 2nd OA to boot