BladeSystem - General
1747985 Members
4956 Online
108756 Solutions
New Discussion

c7000 cisco blade Switch 3020

 
SOLVED
Go to solution
mo ali_1
Occasional Contributor

c7000 cisco blade Switch 3020

 

Hi i have a hp c7000 blade system and with it two cisco switches i have configured the oa and other parts of the enclosure but i am not sure about how i should configure the network switches, below are some of the concerns i have.

 

1. Do the blade switches require configuration or should i just connect it directly to my distribution/access switches (i have loop guard enabled on this switches).

2.if configuration is required what are the basic configurations required to get me up and started.

 

thanks in advance your replies.

2 REPLIES 2
Robert_Jewell
Honored Contributor
Solution

Re: c7000 cisco blade Switch 3020

How you should configure them is up to your environment and needs, right?

 

Here are some links to docs that should help:

 

http://h18004.www1.hp.com/products/blades/components/c-class-tech-installing.html

   Scroll down about 2/3rds and you will see the Cisco switches.

 

http://www.cisco.com/en/US/products/ps6748/tsd_products_support_series_home.html

 

-Bob

----------------
Was this helpful? Like this post by giving me a thumbs up below!
mo ali_1
Occasional Contributor

Re: c7000 cisco blade Switch 3020

Thanks, i also found a good document on bladesytem into cisco data center network architecture, which covers the different designs of deployment.