HPE Community
BladeSystem - General
1753340 Members
5330 Online
108792 Solutions
New Discussion

c7000 dual OA won't take EBIPA - goes back to DHCP

 
Don Vanco - Linux Ninja
Regular Advisor

‎04-30-2009 07:11 AM

‎04-30-2009 07:11 AM

c7000 dual OA won't take EBIPA - goes back to DHCP

I have a c7000 chassis that won't "keep" it's IP addressing. Device bays keep going back to DHCP.

Anyone seen this issue?
0 Kudos
Reply
1 REPLY 1
Gary Benavides Meza
Trusted Contributor

‎04-30-2009 09:05 AM

‎04-30-2009 09:05 AM

Re: c7000 dual OA won't take EBIPA - goes back to DHCP

Did you select the check box "Enabled". If you don't check it it will get the IP assigned by the external DHCP Services

Note: If each interconnect has been previously given a static IP address, these EBIPA settings will not change the static IP address. If the interconnect management IP address has been configured via an external DHCP service, the EBIPA settings will override the existing DHCP address
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.