- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Can you Enclosure Bay IP Address (EBIPA) AutoFill ...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-11-2013 06:18 AM
01-11-2013 06:18 AM
Can you Enclosure Bay IP Address (EBIPA) AutoFill via the CLI?
Dan was looking for some help with setting Enclosure IP Addresses:
******************
I know you can do it in the Web GUI, but is there a way to do this in the CLI interface?
Setup 1 Server EBIPA entry and AutoFill the rest or some hidden AutoFill switch you add when assigning an EBIPA IP?
The current (OCT 2012) CLI Guide has Zero instances of “autofill” and “auto fill” so I am not hopeful.
************
Chris replied:
****************
Use the following and it will auto populate:
#Set Enclosure Bay IP Addressing (EBIPA) Information
SET EBIPA SERVER 172.20.20.102 255.255.0.0 1-16
SET EBIPA SERVER GATEWAY 172.20.0.1 1-16
ADD EBIPA SERVER DNS 4.2.2.2
ENABLE EBIPA SERVER 1-16
DISABLE EBIPA SERVER 1A-16A, 1B-16B
Save EBIPA
Notice the bay ID’s at the end of the first two lines.
****************
Any other questions or comments?