BladeSystem - General
1748181 Members
3373 Online
108759 Solutions
New Discussion юеВ

Re: cluster BL870c-OA login

 
kuzo_1
Occasional Contributor

cluster BL870c-OA login

I have a new c7000 with two servers blade to install with a cluster BL870c . but I have problem to the config of Enclosuer. where can I find the login of the OA. I did not see it on stiker to the enclosure. it is with license Key whom I am going to have him(it)?

KUZO
4 REPLIES 4
Steven Clementi
Honored Contributor

Re: cluster BL870c-OA login

On the OA, there is a pull out tab. It's gray graphite in color i think. Look on the back of the enclosure at the OA.

On the Tab is the default password and name.


Steven
Steven Clementi
HP Master ASE, Storage, Servers, and Clustering
MCSE (NT 4.0, W2K, W2K3)
VCP (ESX2, Vi3, vSphere4, vSphere5, vSphere 6.x)
RHCE
NPP3 (Nutanix Platform Professional)
Torsten.
Acclaimed Contributor

Re: cluster BL870c-OA login

Normally there should be a sticker with the login credential written on it. However, if you pull the OA (left is primary by default) the login is written on the bottom side.
If you pull and push it back, the other OA became active meanwhile.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
David Claypool
Honored Contributor

Re: cluster BL870c-OA login

If all else fails you can connect to the OA via a serial cable and do a password recovery. See the User Guide for details.
kuzo_1
Occasional Contributor

Re: cluster BL870c-OA login

Tanks