Configuring a new Flex-10 Ethernet network

[dbx13]

We have a C7000 with redundant Flex-10 modules, and it's all pretty new to us.

Port 2 on each Flex 10 is connected to our production network and I am able to access the network from member blade servers.

Now I have created a new Flex-10 Ethernet network named Hyper-V, and have wired in port 1 from each flex 10 to our production switches. On the back of the Flex 10's I can see that there is activity on both ports 1 and 2 (flashing amber LED) but while port 2 is lit in green, port 1 is not.

Then back to the Hyper-V ethernet network, I am unable to add port 1 to that new network using the Add Port button in the GUI.

How do I make this second set of connections available to the blade BL460-G6 servers?

Thanks!

[JKytsi]

port1 is shared with cx-4 port, do You have that in use ?

[dbx13]

I realise now that the VC Manager is not supported under IE8. All is well under IE6. Jarkko, thank you for your reply.

[dbx13]

Sol'n: Use IE7 or 6 to run the VC Manager.