BladeSystem - General
1745834 Members
4174 Online
108723 Solutions
New Discussion

Configuring SNMP v1 on Gb2Ec Blade Switch using isCLI

 
fisherman_steve
Occasional Contributor

Configuring SNMP v1 on Gb2Ec Blade Switch using isCLI

Can anyone tell me how to configure SNMP on the above using the isCLI?

I have done it on switches using the menu-based CLI but cannot work out exactly whats needed using the isCLI despite spending alot of time on it without success.  No messages are being sent to the IP address of my SNMP trap receiver.

 

Thanks in advance,

Steve