HPE Community
BladeSystem - General
1752777 Members
6278 Online
108789 Solutions
New Discussion

Configuring uplinks with CX4 ports on Virtual Connect 1/10Gb Ethernet module

 
A.W.R
Frequent Advisor

‎02-11-2008 03:58 AM

‎02-11-2008 03:58 AM

Configuring uplinks with CX4 ports on Virtual Connect 1/10Gb Ethernet module

Hi,

We have a Blade System Chassis with 2 by Virtual Connect 1/10Gb Ethernet modules. Each ethernet module has 2 by 10Gb CX4 uplink ports.

Is it possible to configure each CX4 uplink port to connect to a different network, or do the ports have to be connected redundantly i.e. port 1 switch 1 to network A, port 1 switch 2 to network A etc.?

Thanks
Andrew
0 Kudos
Reply
1 REPLY 1
HEM_2
Honored Contributor

‎02-12-2008 06:59 AM

‎02-12-2008 06:59 AM

Re: Configuring uplinks with CX4 ports on Virtual Connect 1/10Gb Ethernet module

Andrew:

the 10GB CX4 uplinks on Virtual Connect are independent switch ports and can be connected to different networks. They do not have to be connected redundantly.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.