HPE Community
BladeSystem - General
1752781 Members
6470 Online
108789 Solutions
New Discussion юеВ

How to configure RAID on BL490c with SATA SSDs?

 
Dirk Melchers
Occasional Contributor

тАО09-24-2009 01:54 AM

тАО09-24-2009 01:54 AM

How to configure RAID on BL490c with SATA SSDs?

Hi,

I'm trying to configure the pre-installed SSD drives into a RAID1 configuration on a BL490C. I was expecting to get a prompt to press F8 to enter the ORCA, but that's not the case as shown in the screenshot below. Does anybody have any idea how to get the volumes setup? The box itself is running ESXi.

Thanks in advance and best regards,

Dirk
0 Kudos
2 REPLIES 2
JKytsi
Honored Contributor

тАО09-24-2009 03:52 AM

тАО09-24-2009 03:52 AM

Re: How to configure RAID on BL490c with SATA SSDs?

There is no Smart Array controller in BL490.
And no HW RAID can be configured. Only software mirroring what OS supports.
Remember to give Kudos to answers! (click the KUDOS star)

You can find me from Twitter @JKytsi
0 Kudos
Dirk Melchers
Occasional Contributor

тАО09-24-2009 03:58 AM

тАО09-24-2009 03:58 AM

Re: How to configure RAID on BL490c with SATA SSDs?

Thanks for the quick response!
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.