HP Blade CClass7000 Virtual connect module

[CowBoy]

Dear All
I have Blade c7000 with HP switch(Virtual connect module).
The problem is that we can not config VCM(virtual connect module[VC-ENET 1/10G]) because VC-MODE is disabled so in ILO Onboard administration has not Virtual connect manager optin .
Is There any license to enable that mode or something else ?????
I want to create VLAN on The Switch?????

[Niels Vejrup Pedersen]

Hello,

Are you missing the link to the Virtual Connect Manager, or ?

Please check that you have firmware (OA, BIOS, ILO, VC) in a supported mix.

http://h18004.www1.hp.com/products/blades/components/c-class.html#tab3_content

Check the Compatibility tab.

Regards,

[Kritao]

Hi,

It could be firmware issue only. Since you are not getting the access to configure Virtual connect Manager, you will not be able to update the firmware. So please download VC firmware update command line utility along with the latest VC firmware to update the Firmwares.

[JKytsi]

Have You set the enclosure bay IP addressing ?? Without management IP the VC module is quite hard to manage....