1753973
Members
7829
Online
108811
Solutions
Hello,
I have a C7000 enclosure but I cannot see HP Virtual connect in HP BladeSystem Onboard Administrator.
I have the latest firmware.
Thanks
First I would check in EPIBA if the modules get an IP address and point the browser directly to this address.
Hope this helps!
Regards
Torsten.
__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!
If you feel this was helpful please click the KUDOS! thumb below!
Click on enclosure settings on the left, then Enclosure Bay IP Addressing (EBIPA), then interconnect bays.
look at current address on the right.
Hope this helps!
Regards
Torsten.
__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!
If you feel this was helpful please click the KUDOS! thumb below!
Does it work now?
Hope this helps!
Regards
Torsten.
__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!
If you feel this was helpful please click the KUDOS! thumb below!