ICE on c class blades

[Jeff Gawthorpe]

Hi There,
My company has recently purchased a couple of c3000 blade enclosres with full Insight Control Environment. I have no experience with any of this and have just been told to make it work! I'm a bit stuck. Could someone advise me what ICE is exactly (I'm assuming it's an extension of HP SIM) and how I install/configure on the blades & enclosures. I've tried looking for Install guides but cannot find anything that really helps. Thanks in advance.

[JKytsi]

To get installation started

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00700892/c00700892.pdf

and the rest of manuals

http://h20000.www2.hp.com/bizsupport/TechSupport/DocumentIndex.jsp?contentType=SupportManual〈=en&cc=us&docIndexId=64179&taskId=101&prodTypeId=18964&prodSeriesId=2512052

[Jeff Gawthorpe]

Thanks Jarkko. I'll have a good read of these.

[Jeff Gawthorpe]

Solution submitted in forum

[JKytsi]

good thing it helped. But read also the forum userguide. You should assign points to answers that helped YOU.

[Jeff Gawthorpe]

Hi Jarkko,
Could you please elaborate on your reply as I don't quite understand what you mean. I assigned points because I had previously struggled to find documentation, your answer was therefore extremely useful to me. I have found these forums very helpful and would not wish to offend anyone or do the wrong thing.

Cheers

Jeff

[JKytsi]

Hello,

Here is a link to "forum etiquette"
http://66.34.90.71/ITRCForumsEtiquette/after.html

Now it's too late, because You closed the issue.

[Jeff Gawthorpe]

I'm still non the wiser