HPE Community
BladeSystem - General
1752808 Members
5883 Online
108789 Solutions
New Discussion

Re: iLO to BL460 G6 is not working thru OA

 
Carolyn_8
Frequent Advisor

‎10-20-2009 03:42 PM

‎10-20-2009 03:42 PM

iLO to BL460 G6 is not working thru OA

Got 2 new bl460c G6 and plugged into C7000. One shows up fine in OA, the other does not- I do not see the OA user added for that blade which I think is normally automatically added? I seem to recall an Advisory about positioning bl460G6 blades in a C7000 but I am not finding it. OA says network connection error. We can get to the iLO just using a browser but not thru OA. How can I fix this? iLO fw is 1.77. OA fw is 2.51.
0 Kudos
1 REPLY 1
Carolyn_8
Frequent Advisor

‎10-20-2009 05:07 PM

‎10-20-2009 05:07 PM

Re: iLO to BL460 G6 is not working thru OA

Upgraded the OA firmware to 2.60 and iLO to 1.79 and now it is working.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.