HPE Community
BladeSystem - General
1752796 Members
5671 Online
108789 Solutions
New Discussion юеВ

Re: Interconnect io module is not supported by HP

 
Nismo_1
Occasional Contributor

тАО02-02-2009 08:35 AM

тАО02-02-2009 08:35 AM

Interconnect io module is not supported by HP

Device identification data error
and
The device is not supported by Hewlett-Packard


On c7000 getting these errors above. I have re-seated the IC, but has not cleared the error. Is there anything that can be done?
0 Kudos
Reply
4 REPLIES 4
Steven Clementi
Honored Contributor

тАО02-02-2009 10:43 AM

тАО02-02-2009 10:43 AM

Re: Interconnect io module is not supported by HP

Have you restarted the Onboard Admin Module?
Steven Clementi
HP Master ASE, Storage, Servers, and Clustering
MCSE (NT 4.0, W2K, W2K3)
VCP (ESX2, Vi3, vSphere4, vSphere5, vSphere 6.x)
RHCE
NPP3 (Nutanix Platform Professional)
0 Kudos
Reply
Nismo_1
Occasional Contributor

тАО02-02-2009 12:07 PM

тАО02-02-2009 12:07 PM

Re: Interconnect io module is not supported by HP

Yes
0 Kudos
Reply
Raghuarch
Honored Contributor

тАО02-02-2009 01:16 PM

тАО02-02-2009 01:16 PM

Re: Interconnect io module is not supported by HP

What is the interconnect you are using?

I have seen it once, it was CISCO 3020, it was due to seating problem. I removed the IC and Inserted it with little force ..it started working fine ...
If you insert it very slowly it you may see this. I would suggest remove and Insert again.
0 Kudos
Reply
Nismo_1
Occasional Contributor

тАО02-02-2009 01:37 PM

тАО02-02-2009 01:37 PM

Re: Interconnect io module is not supported by HP

Yes, I reseated with force. HP is coming to replace it.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.