HPE Community
BladeSystem - General
1753621 Members
6021 Online
108797 Solutions
New Discussion

Re: (odd) BL465c ilo fault

 
Iain Radford
Occasional Contributor

‎10-12-2007 03:55 AM

‎10-12-2007 03:55 AM

(odd) BL465c ilo fault

We have a C7000 enclosure with 9 BL465c installed all with dual port HBA's. One of the blades becomes inaccessible via its ilo shortly after booting. When switched on it is possible to ping the ilo for a while then it stops responding - it is configured correctly. The system board has been swapped, the HBA removed and the memory swapped just in case something was dragging it down. It has been tried in different (known working) bays but all to no avail. Server firmware & Enclosure firmware at latest releases. Fresh out of ideas so over to you lot. Any help appreciated.
0 Kudos
Reply
1 REPLY 1
Raghuarch
Honored Contributor

‎10-12-2007 04:23 AM

‎10-12-2007 04:23 AM

Re: (odd) BL465c ilo fault

Hi Radford,

What message r u getting in RBSU.
Can you Access ILO through F8 prompt in RBSU.

Did you try to Access ILO through OA.

What is the error message you are getting when
you try to Access it through OA.

Regards,
Raghuarch
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.