HPE Community
BladeSystem - General
1752794 Members
6214 Online
108789 Solutions
New Discussion юеВ

Re: Pluging the Brocade 8Gb SAN Switch for HP BladeSystem c-7000

 
SOLVED
Go to solution
hrvoje29
Occasional Contributor

тАО01-22-2018 11:52 AM

тАО01-22-2018 11:52 AM

Pluging the Brocade 8Gb SAN Switch for HP BladeSystem c-7000

Hello,

I have c-7000 up and running with 6 blade servers and 3 blade storages. Everything is already in production. All I can find in installation guide is that the Brocade 8Gb SAN Switch is a hot-pluggable device and now I just want to be sure that if I plug in the san switch it will not interfere with running configuration. Can someone please confirm?

Thank you. Regards,

H.

0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

тАО01-22-2018 01:07 PM

тАО01-22-2018 01:07 PM

Solution

Re: Pluging the Brocade 8Gb SAN Switch for HP BladeSystem c-7000

plug in is not a problem, pull out can be a problem, once in use...

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Reply
hrvoje29
Occasional Contributor

тАО01-23-2018 06:37 AM

тАО01-23-2018 06:37 AM

Re: Pluging the Brocade 8Gb SAN Switch for HP BladeSystem c-7000

Thank you Torsten,

It went well :)

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.