problem with blade c465G7 in enclouser c7000

[hurinsky]

Hello, I have problem with new blade servers in enclouser c7000. in this enclouser running bl c460, c865, and new server c465G7. any server running and new 465G7 not start and run. OA has firmware version 3.21, but enclouser has version. 2.60. he can 3.10. where I may download this version?thanks

[Johan Guldmyr]

Hi, you can find previous verisons of the OA firmware here:

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=3709945&prodSeriesId=4132949&swItem=MTX-18107ca743dd482c838f812d6e&prodNameId=4132827&swEnvOID=1005&swLang=8&taskId=135&mode=5

But, it's probably a good idea to run everything in a supported set. You can use the Firmware Maintenance DVD to do that.

[Torsten.]

Its always a problem and it is confusing if you open multiple threads about a single problem!



Your OA firmware (2.60) is too old - update!

[hurinsky]

thank you for response. On all components OA look at me firmware version 3.21, but for this 2 servers I have firmware 2.60.

[hurinsky]

hello , we`re replace midplaine in blade enclouser, and upgrade firmware OA on version 3.30. After replace,VC does not running corectly. ping from servers is OK, but when we can connect on VC, he send message VC UI connect los. please help me with this problmem. thanks

[Torsten.]

Did you set the enclosre serial# *before* inserting the interconnect modules?