HPE Community
BladeSystem - General
1753784 Members
7123 Online
108799 Solutions
New Discussion

Shut down a blade bay completely?

 
chuckk281
Trusted Contributor

‎03-11-2012 05:28 PM

‎03-11-2012 05:28 PM

Shut down a blade bay completely?

Edvard had a question:

 

***************

 

Can I shut down a blade bay completly (virtually removing the power) from a bay in a c7000 chassi remotely.  Instead of just shut down the blade?

 

************

 

Steve replied:

 

****************

 

You can't perminantly shut down a bay.  You can do a reset server # which will tempoarily reset the server, similar to removing and re-inserting the server.

 

****************

 

Any other info for Edvard?

0 Kudos
Reply
2 REPLIES 2
Goutham_Sabala
Esteemed Contributor

‎03-12-2012 06:22 AM

‎03-12-2012 06:22 AM

Re: Shut down a blade bay completely?

I do not think power to the bay itself can be cut out, it is just the server that can be powered off but not the bay 

Was the post useful? Say thanks by clicking the white KUDOS Star!
Goutham Sabala
0 Kudos
Reply
Torsten.
Acclaimed Contributor

‎03-12-2012 06:30 AM

‎03-12-2012 06:30 AM

Re: Shut down a blade bay completely?

As said above, the "reset server" command powers the slot off for a moment, so the server itself and the ilo get a reset/power cycle.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.