BladeSystem - General
1748163 Members
3655 Online
108758 Solutions
New Discussion юеВ

Re: Virtual Connect 3.01 and BL685G6s Where is LOM3a and 4?

 
kheller2
Frequent Advisor

Virtual Connect 3.01 and BL685G6s Where is LOM3a and 4?

Using VC 3.01 on a 7000 chassis, I no longer can see how to assign networks to LOM3 and 4 in the profile settings. I can only set up LOM1 and 2.

This was working fine in the previous version of VC, but the new version is not as fast or nice.
4 REPLIES 4
Michael Leu
Honored Contributor

Re: Virtual Connect 3.01 and BL685G6s Where is LOM3a and 4?

In the profile screen of you BL685G6 you have to click on one of the existing LOMs and then right click -> add.

> but the new version is not as fast or nice.
That's a very polite way of putting it ;-)
kheller2
Frequent Advisor

Re: Virtual Connect 3.01 and BL685G6s Where is LOM3a and 4?

You're kidding? I miss the old table view from prior to this, especially when clicking on "assigned profiles".

HP.. you need a consistent and good UI. I have a few books you could borrow.

Now.. on to my next issue...

When disabling the ASR from hpasmcli..
ERROR: Failed to get ASR enabled state.
Michael Leu
Honored Contributor

Re: Virtual Connect 3.01 and BL685G6s Where is LOM3a and 4?

So did it work?

Yeah sadly they aren't kidding with this UI.. they probably had too much trouble with supporting customers who have IE6 only, so they moved to flash. :-(
kheller2
Frequent Advisor

Re: Virtual Connect 3.01 and BL685G6s Where is LOM3a and 4?

yes that worked, thank you. Since when do you right click on a web interface? 2.33's web interface was better. :) This flash stuff is slow and rather annoying. I feel a changing of the guards at HP.

Mind you none of this stuff works correctly on Safari on a Mac (I think there is a bug with regards to that in the web engine).