- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Virtual Connect Manager not importing enclosure
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-18-2014 05:20 PM
11-18-2014 05:20 PM
Virtual Connect Manager not importing enclosure
Hello
I have a problem where I have 4 c7000 chassis that were running fine are now not importing the enclosures after a firmware update of the OA to 4.22. VC firmware at 3.3
I reset the VC's and the OA's and recreated the the OA's config.
when I connect to the primary OA and try to import the enclosure through the GUI wizard I get the "enc0 is not imported. Please make sure the OA is not part of another VC Domain and that the OA credentials are correct"
If I try to do the import via the cli i get the following error
->show enclosure
=================================================================
ID Name Import Status Serial Number Part Asset Tag
Number
=================================================================
enc0 h036 NotImported SGHXXXXXXXXX
->remove enclosure enc0
ERROR: This is the primary enclosure in the domain and it cannot be removed
->import enclosure
Importing enclosure, please wait...
ERROR: Request to import Local Enclosure failed: Error undefined error
typeImport Failed
->
If I try to import an enclosure through the non primary OA that fails
"Unable To Connect to the Onboard Administrator"
This is getting very frustrating
Thanks
Grant